H3C S5150-EI Series, Installation Manual

Page: 62 / 73

54
LEDs
Table 20 S5150-EI switch LEDs at a glance
LED Switch Remarks
System status LED All switch models See Table 21 .
Power module status LED
S5150X-16S-EI
S5150-24S-PWR-EI
See Table 22 .
RPS status LED S5150X-16ST-EI See Table 23.
Port mode LED S5150-24S-PWR-EI See Table 24 .
Management Ethernet port LED
S5150X-16S-EI
S5150X-16ST-EI
See Table 25 .
1/10GBASE-T autosensing Ethernet
port LED
S5150X-16S-EI See Table 26 .
2.5G/1000/100BASE-T autosensing
Ethernet port LED
S5150-24S-PWR-EI See Table 27 .
SFP+ port LED All switch models See Table 28 .
System status LED
The system status LED shows the operating state of the switch.
Table 21 System status LED description
LED mark Status Description
SYS
Steady green The switch is operating correctly.
Flashing green (1 Hz) The switch is performing power-on self test (POST).
Steady red The switch has failed the POST or is faulty.
Flashing yellow (1 Hz) Some ports have failed to pass POST or are faulty.
Off The switch is powered off.
Power module status LED
The S5150X-16S-EI and S5150-24S-PWR-EI switches provide two power module slots at the rear.
For each power module, these switches provide a power module status LED on the front panel. For
more information about power modules, see the related power modules user manual.
Table 22 Power module status LED description
LED mark Status Description
PWR1
Steady green
A power module is installed in power module slot 1, and the power
module is outputting power correctly.
Steady yellow
A power module is installed in power module slot 1, but the power
module has failed or no power is input to the power module.
Off No power module is installed in power module slot 1.