176
Step Command
Remarks
4.
Configure the link type of
the ports as trunk.
port link-type trunk
Access by default.
For more information about the
port link-type trunk
command,
see
Layer 2—LAN Switching
Command Reference
.
5.
Assign the trunk ports to
all VLANs.
port trunk permit vlan all
By default, a trunk port is
assigned to VLAN 1 only.
For more information about the
port trunk permit vlan all
command, see
Layer 2—LAN
Switching Command Reference
.
6.
Enable GVRP on the
ports.
gvrp
Disabled by default.
7.
Configure the GVRP
registration mode on the
port.
gvrp registration
{
fixed
|
forbidden
|
normal
}
Optional.
normal
by default.
Configuring the GARP timers
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Configure the GARP
LeaveAll timer.
garp timer leaveall
timer-value
Optional.
1000 centiseconds by default.
The LeaveAll timer applies to all
ports.
3.
Enter Ethernet interface view,
Layer 2 aggregate interface
view, or port group view.
•
Enter Ethernet interface view or
Layer 2 aggregate interface view:
interface
interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
Use either command.
4.
Configure the Hold timer.
garp timer hold
timer-value
Optional.
10 centiseconds by default.
5.
Configure the Join timer.
garp timer join
timer-value
Optional.
20 centiseconds by default.
6.
Configure the Leave timer.
garp timer leave
timer-value
Optional.
60 centiseconds by default.
As shown in
, the value ranges for GARP timers are dependent on one another; use the
following guidelines to configure GARP timers:
•
If you want to set a value beyond the value range for a timer, you can change the value range by
tuning the value of another related timer.
