H3C S12500R Series, Installation, Quick Start

Page: 16 / 33

3-2
5.
As shown by callout 4 in Figure 3-1 , continue to push the MPU by its middle part on the front
panel until you cannot move it.
6.
As shown by callout 5 in Figure 3-1 , push the ejector levers inward until they come in close
contact with the front panel.
7.
As shown by callout 6 in Figure 3-1 , fasten the captive screws on the MPU.
Figure 3-1 Installing an MPU (S12516R)
(1) Loosen the captive screws and remove the filler panel
(2) Insert the MPU into the slot
(3) Pull the ejector levers outward
(4) Push the MPU by the middle part on the front panel
(5) Pull the ejector levers inward
(6) Fasten the captive screws
Installing MPUs for the S12504R
The S12504R MPU marks and MPU slot edges are pink-marked.
To install an MPU for the S12504R:
1.
As shown by callout 1 in Figure 3-2 , remove the filler panel from the target MPU slot.
Keep the removed filler panel secure for future use.
2.
As shown by callout 2 in Figure 3-2 , pivot up the handle of the MPU.
3.
As shown by callout 3 in Figure 3-2 , orient the MPU with lettering on it upright. Push the MPU
slowly and steadily into the slot along the guide rails. Avoid touching other components in the
chassis.
4.
As shown by callout 4 in Figure 3-2 , push the MPU until the handle makes close contact with
the slot edges.
5.
As shown by callout 5 in Figure 3-2 , continue to push the MPU handle until the MPU is secure
in position.
6.
Fasten the captive screws on the MPU.
1
2
3
3
4
5
5
6