H3C S10504, Installation Manual

Page: 80 / 115

72
Air filters
CAUTION:
Clean air filters periodically (at least once every three months) to guarantee adequate ventilation and
avoid over-temperature.
To prevent dusts from entering the chassis, you can configure air filters for the switch as needed and
install the air filters at the air intakes.
The H3C S10500 Switch Series air filters include the S10504 air filter, the S10508 air filter, the
S10508-V air filter, and the S10512 air filter. Order air filters compatible with your switch.
Transceiver modules
The switch supports transceiver modules. You can order transceiver modules according to the transceiver
modules supported by the LPU interfaces. For more information, see Table 19 .
The switch supports the following transceiver modules:
•
10-Gigabit XFP modules listed in Table 23
•
10-Gigabit SFP+ modules listed in Table 24
• 10-Gigabit SFP+ cables listed in Table 25
•
Gigabit SFP modules listed in Table 26
•
100-Mbps SFP modules listed in Table 27
•
QSFP+ modules listed in Table 28
• QSFP+ cables listed in Table 29
•
QSFP+ to SFP+ cables listed in Table 30
•
40-Gigabit CFP module listed in Table 31
• 100-Gigabit CFP module listed in Table 32
Table 23 XFP module specifications
10-Gigabit XFP
module
Central
wavelength
Connec
tor
Cable
specifications
Modal
bandwidth
Maximum
transmission
distance
XFP-SX-MM850 850 nm LC
50/125 μ m
multimode fiber
2000
MHz*km
300 m (984.25 ft)
500 MHz*km 82 m (269.03 ft)
400 MHz*km 66 m (216.54 ft)
62.5/125 μ m
multimode fiber
200 MHz*km 33 m (108.27 ft)
160 MHz*km 26 m (85.3 ft)
XFP-LX-SM1310 1310 nm LC
9/125 μ m
single-mode fiber N/A
10 km (6.21 miles)
XFP-LH40-SM1550 1550 nm LC
9/125 μ m
single-mode fiber N/A
40 km (24.86 miles)