101
Repackaging the card
1.
Prepare the anti-static bag and box of the card. Make sure the bag is clean, dry, and not
damaged.
2.
Remove the transceiver modules from the card. If no transceiver module is installed on the card, go
to the next step.
For how to remove a transceiver module, see "
3.
Remove all cards from the chassis slots, and install blank filler panels to the empty slots.
For how to remove a card and install a blank filler panel, see "
4.
Put the card into the anti-static bag. The switching fabric module on an S10508, S10508-V, or
S10512 has a protection box. Put the switching fabric module into the protection box, and then
put the box into the anti-static bag.
5.
Put the packed card into the box, and tape the flaps of the box with packing tape. Place the card
in a correct direction onto the foam cushion in the box; otherwise, the power module cannot be
completely seated into the foam cushion.
Repackaging the switch chassis
Removing the chassis from the rack
S10500 switches are heavy. If possible, use a mechanical lift to move the switch.
To remove the chassis from the rack:
1.
Prepare the wooden carton and packing bag of the chassis. Make sure the carton and bag are
clean, dry, and not damaged.
2.
Remove the top cap and side panels from the wooden carton, and put the pallet base to a secure
place.
3.
As shown in callout 1 in
, use a Phillips screwdriver to loosen the screws that attach the
mounting brackets to the rack.
4.
As shown in callout 2 in
, use at least two persons to slide the chassis outwards along the
slide rails. When most part of the chassis is removed from the slide rails, lift up the chassis by
holding the handles at the chassis sides to completely remove the chassis from the rack.
