7
3.
Connect the other end of the AC power cord to the AC power
source, and turn on the circuit breaker.
4.
Examine the AC OK LED on the power module. If the LED is
steady green, the power cord is connected correctly. If the LED
is off, examine the installation, troubleshoot the problems, and
try again until the LED is steady green.
Removing the power module
To avoid bodily injury or device damage, follow the procedure
in
to remove the power module.
Figure 6 Removing procedure
To remove the power module:
1.
Turn off the circuit breaker at the power input end.
2.
Put on the ESD wrist strap and make sure the strap makes good
skin contact and is reliably grounded.
3.
Loosen the cable tie and remove the power cord.
4.
As shown in
, press the latch towards the handle, and
pull the power module part way out of the slot along the guide
rails.
5.
Holding the power module handle with one hand and supporting
the power module bottom with the other, pull the power module
slowly out of the slot along the guide rails.
6.
Put the removed power module on an antistatic mat or into its
package.
7.
If you are not to insert a power module into the empty slot, insert
the filler panel into the slot to prevent dust from entering the
chassis.
