background image

Manual version: 6PW105-20190725 

BOM:3123A0R9

 

H3C NSQ1TGS32SF0 interface module 

 

Module view 

Figure 1 NSQ1TGS32SF0 interface module 

 

 

 

Specifications 

Figure 2 Front panel 

 

 

Table 1 Module specifications 

Item Specification 

Dimensions (H × W × D) 

40 × 399 × 352 mm (1.57 × 15.71 × 13.86 in) 

Power consumption 

126 W to 170 W 

Weight 

3.45 kg (7.61 lb) 

Hot swapping 

Supported 

Connector type 

LC 

Interfaces 

32 10-GE-SFP+ ports 

Interface transmission rate 

10/1 Gbps 

Ambient temperature 

 

Operating: 0°C to 45°C (32°F to 113°F) 

 

Storage: –40°C to +70°C (–40°F to +158°F) 

Ambient humidity 

 

Operating: 10% RH to 95% RH, noncondensing 

 

Storage: 5% RH to 95% RH, noncondensing 

Summary of Contents for NSQ1TGS32SF0

Page 1: ...cification Dimensions H W D 40 399 352 mm 1 57 15 71 13 86 in Power consumption 126 W to 170 W Weight 3 45 kg 7 61 lb Hot swapping Supported Connector type LC Interfaces 32 10 GE SFP ports Interface transmission rate 10 1 Gbps Ambient temperature Operating 0 C to 45 C 32 F to 1 13 F Storage 40 C to 70 C 40 F to 158 F Ambient humidity Operating 10 RH to 95 RH noncondensing Storage 5 RH to 95 RH non...

Page 2: ... Connector type Fiber diameter Modal bandwidth MHz km Maximum transmission distance SFP XG SX M M850 A 850 LC 50 125 μm MMF 2000 300 m 984 26 ft 500 82 m 269 03 ft 400 66 m 216 54 ft 62 5 125 μm MMF 200 33 m 108 27 ft 160 26 m 85 30 ft SFP XG LX22 0 MM1310 1310 LC 62 5 125 μm MMF 500 220 m 721 78 ft 50 125 μm MMF 500 220 m 721 78 ft 400 100 m 328 08 ft SFP XG LX S M1310 1310 LC 9 125 μm SMF N A 10...

Page 3: ...on a flat surface with the components facing up Open the ejector levers on the module 4 Gently push the module into the slot along the guide rails See callout 1 in Figure 3 5 Close the ejector levers and make sure the module is in close contact with the backplane See callout 2 in Figure 3 6 Use a Phillips screwdriver to fasten the captive screws on the module See callout 3 in Figure 3 Figure 3 Ins...

Page 4: ...ule from the backplane and pull the module slowly out of the chassis along the guide rails 3 Place the module on an anti static workbench or put it in an anti static bag with the components side facing up 4 If you are not to install a new module install a filler panel in the slot to prevent dust and ensure good ventilation in the device Copyright 2019 New H3C Technologies Co Ltd The information in...

Reviews: