8
Connecting a power adapter
You can power the S9G switch by using a power adapter.
To connect the power adapter:
1.
Connect the DC connector of the power adapter to the DC
power receptacle on the switch.
2.
Connect the plug of the power adapter to an AC power source.
Installing an SFP transceiver module and
optical fibers
CAUTION:
•
When you install or remove an SFP transceiver module, do
not touch the golden plating on it.
•
Remove the dust plugs from an SFP transceiver module
only when you are to connect optical fibers to the module.
•
Before installing an SFP module, remove the optical fibers,
if any, from it.
To install an SFP transceiver module and optical fibers:
1.
Wear an ESD wrist strap and make sure it makes good skin
contact and is reliably grounded.
2.
Pivot the bail latch of the module up. Holding the module by its
two sides, gently push the module into the slot until it has firm
contact with the slot.
