Manual version: APW100-20220530
BOM: 3123A2AL
ii
Item
Specifications
Power consumption
170 to 385 W
SSD hot swapping
Not supported
Ports
•
3 × 10GBASE-R-SFP+ fiber ports
•
1 × 10GBASE-R-SFP+ HDM shared network port (used for Ethernet
connection or HDM access)
•
2 × 1TB data drive ports
•
1 × SUV port (using an SUV connector)
•
1 × USB 3.0 port
•
2 × console port (used by technical support for debugging only)
•
1 × 10/100/1000BASE-T management Ethernet port (used by
technical support for debugging only)
•
1 × 10/100/1000BASE-T HDM dedicated network port (default IP
address: 192.168.1.2/24)
NOTE:
The HDM shared network port obtains IP addresses through DHCP
automatically.
Ambient temperature
•
Operating: 5°C to 40°C (41°F to 104°F)
•
Storage: –40°C to +70°C (–40°F to +158°F)
Ambient humidity
•
Operating: 5% RH to 95% RH, noncondensing
•
Storage: 5% RH to 95% RH, noncondensing
Table 2 10/100/1000BASE-T management Ethernet port specifications
Item
Specification
Connector
RJ-45
Standard
802.3, 802.3u, and 802.3ab
Auto-MDI/MDIX
Supported
Cable
Category 5 or above twisted pair cable
Transmission distance
100 m (328.08 ft)
Rate and duplex mode
10/100/1000 Mbps, full-duplex mode
NOTE:
•
This module can be used only with Type T fabric modules (such as LSXM1SF
T
08F2) and Type T
supervisor engine units (such as LSXM2SUP
T
2).
•
To verify the compatibility of the module with the software release you are using, see the release
notes.
•
For information about transceiver modules and cables available for the module, see the cards
and transceiver modules compatibility matrixes for the device.