6
LED status
Description
Off
No transceiver module is installed in the port, or no
link is present on the port.
Table 10 QSFP+ port LED description
LED status
Description
Steady green
A transceiver module is installed in the port. The
port is operating at 40 Gbps, and a link is present
on the port.
Flashing green
The port is sending or receiving data at 40 Gbps.
Steady yellow
A transceiver module is installed in the port. The
port is operating at 10 Gbps, and a link is present
on the port.
Flashing yellow The port is sending or receiving data at 10 Gbps.
Off
No transceiver module is installed in the port, or
no link is present on the port.
NOTE:
The QSFP28 port LEDs and QSFP+ port LEDs are not affected by
the port LED mode switching button on your switch. For more
information about the port LED mode switching button, see the
installation guide for the switch.
▌
Installing and removing the card
CAUTION:
•
Before you install or remove the card, wear an ESD wrist strap
and make sure the strap makes good skin contact and is
reliably grounded.
•
To avoid device damage, do not use excessive force when you
install or remove the card.
