H3C LSQM1TGT24QSM0, User Manual, Page: 5 / 6

5
To remove an interface card:
1. Prepare an anti-static bag.
2. Press the latch to release the ejector lever
3. Rotate outward the ejector lever as shown by callout 1 in Figure 4 .
4. Pull out the interface card slowly out of the interface card slot, as
shown by callout 2 in
Figure 4 .
5. Place the removed interface card in the anti-static bag.
Figure 4 Removing an LSQM1TGT24QSM0 interface card
Installing and removing QSFP+ transceiver modules
and DAC cables
For information about installing and removing QSFP+ transceiver
modules and DAC cables, see
H3C QSFP+ Transceiver
Modules/Cables Installation Guide at www.h3c.com .
Verifying the installation
After the installation is complete, identify whether the interface card is
operating correctly.
If the interface card fails to operate correctly, perform the following
steps:
1. Reinstall it following the installation procedures described in this
document.
2. If the problem persists, contact H3C Support.
1
2