8-4
5.
As shown by callout 3 in
, rotate outward the ejector levers of the module to separate
the module connector from the backplane.
6.
As shown by callout 4 in
, use one hand to slowly move the module outwards.
Supporting the bottom of the module with the other hand, pull the module out of the slot along
slide rails.
7.
Put the removed module on the antistatic mat.
8.
Install a new switching fabric module. For the installation procedure, see "Installing switching
fabric modules."
9.
If you are not to install a new switching fabric module, install a filler panel in the switching fabric
module slot to ensure adequate ventilation and prevent dust.
Figure8-6 Removing a switching fabric module
Figure8-7 Installing a filler panel in an unused switching fabric module slot
