PSR1110-56A installed in the slot
A PSR1110-56A power module (including its handle) adds 64 mm (2.52 in) to the chassis depth.
Connecting the power cord
Before connecting the power cord, make sure the switch is reliably grounded.
To avoid bodily injury, connect the power cord first to the switch and then to the equipment-room
power supply system .
A retaining clip or releasable cable tie might be provided for securing the power cord. The
installation position for the retaining clip or releasable cable tie vary by switch model.
The power cord varies by power module. Do not mix power cords.
7
Connecting the power cord for an AC power module
1
2
3
1
Method 1
Installing a power module
Remove a filler panel (skip this step if no filler panel is in the power module slot)
Method 1
Method 2
1
1
2
This section is applicable only to switch models that use removable power modules.
1
2
2
Install and remove a power module (method 1)
Install and remove a power module (method 3)
1
2
Install and remove a power module (method 2)
1
2
1
2
1
Install
Remove
Install
Remove
Install
Remove
8
Install
Remove
2
1
1
