F. How to Use
8
If you have not used the water purifier for more than 2 days, please drain out
about 1 to 2 litres of water using any one of the dispensing buttons on the
operation panel.
Power Connection & Initialization Procedures
When the power supply is connected, the operation panel will
light up, and preparation for dispensing is completed.
•
At initial startup, check for leaks between the product and water
tubing connections.
•
To begin, press any of the dispensing buttons on the operation panel to
drain out about 2 ~ 3L of water before use. (Flushing operation)
•
Flush the filter thorougly and do not worry about the initial noise in the
filters. The flushing will take care of the air that is trapped inside the filter.
This will not happen once the water purifier is initialized for operation.
Taking water
(Pre-set amount of water for auto dispensing)
DuoGuard
TM
can dispense water in 150ml, 500ml and 1 liter.
• There may be an error in the amount of water being dispensed when the flow
rate of the raw water is too low (lower than 500ml/min).
• If you wish to interrupt/stop the water flow before it reaches the pre-set
amount, simply touch/press the button one more time and the water will
stop immediately.
1
2
To start dispensing water, simply press any button selection (1)
or (2), water will start to dispense from the faucet and it will stop
automatically.
•
To dispense 500ml water, press button (1) once
•
To dispense 1 liter of water, press and hold
button (1) for 2 seconds continuously.
•
To dispense 150ml water, press button (2) once
The selected button will be lighted up with a continuous blink,
indicating the water is in a dispensing mode.