10
www.myhtec.com
Troubleshooting
The measured values are not working.
The measured values are determined to be too low.
Should the above-mentioned solutions not remedy the cause of error, please contact
Should the above-mentioned solutions not remedy the cause of error, please contact
H-TEC Education.
H-TEC Education.
The components to be measured are not working properly.
Higher currents can magnify contact resistance.
The components are not connected properly.
The decade resistor is damaged.
Make sure the components to be measured are working properly. For
instructions on troubleshooting with regard to the individual components to be
measure, see the relevant operating instructions.
Check all connections for secure, tight connection. However, the values
measured are accurate in a qualitative sense.
Make sure that all the components are connected as described in the “Use of
the Measurement Set” chapter.
Contact H-TEC Education
Possible Cause:
Possible Cause:
Possible Cause:
Possible Cause:
Solution:
Solution:
Solution:
Solution:
