![H-Root ET02 Operating Manual Download Page 4](http://html1.mh-extra.com/html/h-root/et02/et02_operating-manual_3071674004.webp)
Prime Alternatives Free call 1800 333 505
Lipstick, shoe polishes, fatty & greasy stains:
Remove as much of the stain as possible without rubbing the stain into the vinyl. Wipe over with methylated spirits.
Wash with warm soapy water and dry with clean cloth.
Chewing gum:
Set the gum hard with an ice cube. Then scrape over with the blunt edge of a knife. Wipe over with methylated spirits
and then finish by wiping with warm soapy water.
Pen ink:
Wiping with methylated spirits is sometimes effective if stain is fresh.
Important
Never use furniture polishes, abrasive cleaners, steel wool or cleaners containing solvents as these products can cause
damage to the vinyl surface.
TROUBLE SHOOTING
PROBLEM: MOTOR DOES NOT OPERATE
Possible solution:
Make sure that the motor is receiving electrical power.
Plug another appliance into the wall power socket to ensure that it is operating correctly or try plugging the
table into another wall socket that is known to be working.
Check power plug to see if it is securely plugged into the electric outlet and the cord is not severed or
damaged.
Ensure that the plugs of all leads connected to the motor control box are pushed firmly into their sockets
If you have two foot pedals or another table, try swapping the foot pedals over.
PROBLEM: MOTOR OPERATES - BUT MAKES AN UNUSUAL NOISE
Possible solutions:
Clean and lubricate the motor pivot points as described in the maintenance section of this manual.
PROBLEM: MOTOR OPERATES - IN ONE DIRECTION ONLY
Possible solutions:
Clean and lubricate the motor pivot points as described in the maintenance section of this manual.
Ensure that the plugs of all leads connected to the motor control box are pushed firmly into their sockets.
PROBLEM: END SECTION SLIPS ON ONE OR BOTH SLIDES WHEN WEIGHT IS APPLIED.
Possible solutions:
Clean lock bars and white lock tabs with alcohol wipes or a rag dipped in methylated spirits.
Rub length of lock bars with a light grade of a sandpaper.
Ensure the mounting screws on the white plastic lock tags and the table mounting backs are fully tightened.