6
IV.
ELECTRIC PRINCIPLE DIAGRAM
V.
OPERATION OF WINE COOLER
1. Initial Setup
Locate the wine cooler according to the installation limitations. Once you have
plugged the unit into an electrical outlet, let the unit run for at least 30 minutes before
making any adjustments.
2. Temperature Adjustments
a) Your wine cooler has an electric temperature control on the front of the units.
You can set the temperature of your wine cooler at any setting your desire.
The temperature will range from 8 degree to 18 degree. When initially turned
on, the LED will display the ambient temperature and then the internal cabinet
temperature.
b)
Pressing the ▲ TEMP button on the display will increase the temperature and
pressing the ▼ TEMP button will lower the temperature.
c) After you set your desired temperature, the set temperature numerals will flash
for 5 seconds and then revert to the internal cabinet temperature.
d) Your wine cellar also has a light for your viewing convenience. A light switch
on the control panel will activate the light manually. Under normal
operation it is best for the light to remain off.
e) By pressing the C/F button you can have the temperature readout either in
Celsius or Fahrenheit.
VI. PARTICULAR PRECAUTIONS
•
To assure your wine cooler works at the maximum efficiency it was designed for,
you should install it in a location where there is proper air circulation, plumbing
and electrical connections.
•
The following are recommended clearances around the wine cooler:
o
sides 3/4
"
19mm
o
top 4
"
100mm
o
back 2
"
50mm
•
For proper internal air circulation, do not overfill your wine cooler.
•
Avoiding direct sunshine temperature.
•
Do not place heavy articles on the top of the cellar.