The battery is not fully charged.
Elevator servo is reversed.
C
G too far backwards.
Charge the battery.
Change servo direction via Tx.
Move
battery
1. Transmitter/Receiver batteries
are flat.
Problem
Cause
Solution
Motor does not
Batteries
not fully
charged.
Transmitter battery low.
Motor not connected.
The motor is damaged.
Receiver is not bound to Tx.
ESC in set-up mode.
Control surfaces
not moving with
stick input
Model does not
fly straight
Model does not
climb well
Limited adio
r
ange
1. Charge/replace batteries.
Model moves
backwards
Charge the batteries.
Install a charged battery.
Check
connection
between the ESC and motor.
Replace motor.
Consult adio manual and
go through bind procedure
again.
Hold model and move
throttle to full position then
back down to idle.
1. The servo lead is connected
to Rx incorrectly.
2. The servo is damaged.
Make sure the servo leads
are connect properly.
Replace servo.
Control surfaces
not
centered.
C
G is not in the correct
position.
1. Adjust the trims on the
transmitter.
2. Re-position LiPo as
suggested.
14
TROUBLE SHOOTING
1. Fan is running backwards.
1. Swap any 2 motor wires
over that go to the ESC.
