- 31 -
Video Loss Settings..
– used to setup the action settings when video loss is detected for this
camera. Press
ENTER
in
Settings..
to call up Video Loss Setup display for the camera.
Please refer to
Section 6.2.1
for the details.
Motion Detection
– whether the motion detection of this camera is enabled or not. Press
ENTER
or
+/-
to check/uncheck this item. The default setting is “
ˇ
”
-
checked.
Motion Settings..
– used to setup the motion settings for this camera. Press
ENTER
in
Settings..
to call up Motion Setup display for the camera. Please refer to
Section 6.2.2
for the
details.
Covert
– covert or not. If the camera is covert, the video of this camera can only be seen if
the user has logged in as Administrator. Press
ENTER
or
+/-
to check/uncheck this item.
The default setting is “
–
”
-
unchecked.
Call By Event
– whether to switch the call monitor to the video of this camera if certain event
occurs for this camera. There are 4 options, including Off, Motion, Alarm, Both (Motion &
Alarm). Press
+/-
buttons to select one.
Dwell Time
– the dwell time if
Call By Event
is set to Motion, Alarm, or Both. Press
+/-
buttons to adjust the value (3-60 seconds, discrete).
Audio
– the AUDIO IN corresponding to this camera.
If selected, the audio data for the
selected AUDIO IN will be recorded with the video data for this camera.
Press
+/-
buttons
to select none (N/A) or the AUDIO Inputs (1/2). The default setting is “N/A”.
Record Quality
– the record quality for this camera. Press
+/-
buttons to select the value (1-9,
with 1 the lowest (rough) quality, 9 the highest (fine) quality).
Event Record IPS
– the IPS (Images Per Second) for this camera if certain event (Motion,
Alarm) occurs for this camera. This camera will be recorded at this rate for Post-record time
since the event occurs. (Please refer to the following sections for Post-record time.) Press
+/-
buttons to select the value (0 – 25 (PAL) / 30 (NTSC), discrete).
Pre-record IPS
– the pre-record IPS for this camera if certain event (Video Loss, Motion,
Alarm) occurs for this camera. This camera is recorded at this rate for Pre-record time before
the event occurs. (Please refer to the following sections for Pre-record time.) Press
+/-
buttons to select the value (0 –
Event Record IPS
for this camera, discrete). Please note that
the total
Event Record IPS
/
Pre-record IPS
should not exceed the system recording capacity
(NTSC: 120/CIF, 60/Half-D1, 30/Full-D1; PAL: 100/CIF, 50/Half-D1, 25/Full-D1), or the
system will lower the actual rate automatically at recording.
Normal Record IPS
– the normal record IPS for this camera. This camera will be recorded at
this rate if no event occurs. Press
+/-
buttons to select the value (0 –
Pre-record IPS
for this
camera, discrete).
SCW-7704 User Manual
SCW-7704 User Manual