corrected before the battery is replaced after charging.
CHARGER/MAINTAINER LOCATION:
1. Locate charger as far away from battery as DC cables permit.
2. Never place charger directly above battery being charged. Gases
from battery will corrode and damage charger.
3. Never allow battery acid to drip on charger when reading gravity or
filling battery.
4. Do not operate charger in a closed area or restrict ventilation in any
way.
5. Do not set a battery on top of charger.
SETTING UP & OPERATIONS:
1.
Make sure the room has plenty of ventilation.
2.
Mount SCM54E away from any vehicle repair or service. Make sure
never to start or run an engine near the batteries being charged.
3.
Be sure the total amperage used by SCM54E should not exceed the
amperage capacity of the supply source. If you do not know how to
determine this, have a qualified electrician determine the capacity
for you.
4.
Connect and disconnect DC output clips only after removing AC
cord from electric outlet. Never allow clips to touch each other.
5.
Make sure the battery terminals are clean. Wire brush them if
necessary. Clamp the black lead to the negative battery terminal.
Clamp the red lead to the positive battery terminal.
6.
Connect SCM54E to a grounded power receptacle that is wired in
compliance with local electrical codes.
※
Side mounted batteries will require the insertion of a lead post
adapter. Plain bolts are not safe. They will not allow for accurate
reading and should not be used.
7.
After plugging the AC cord, please turn on the power switch to start
SCM54E.
- GB.5-V1 -
