6
CONNECT 5
EN
PROGRAMME RECALL BY THE CONSOLE
(PRODUCTS WITH TFT SCREENS)
When the console takes control over the machine, it can then recall programmes. The name
of the recalled programme is displayed in the main window.
P1 : TUB 2 mm
PROGRAMMES ALLOCATION
(PRODUCTS WITH KEYPAD)
TIG 300 DC
TIG TITAN 400 DC
Access to allocation table and matching table :
The programme allocation is fixed by default to the first five saved settings.
If no saved setting is recorded on the product : this does not change the operation of the automated system mode, each pro-
gramme will match the default context or free programme.
CONNECT-5 RECOGNITION MODES
(PRODUCTS WITH KEYPAD)
TIG 300 DC
TIG TITAN 400 DC
When plugging in the automated system, 2 recognition modes exist.
1/ A direct recognition mode detecting the short circuit on AUTODETECT, the recognition takes place and the machine starts or goes into CONNECT-5
configuration.
2/ An indirect recognition mode detecting the impedance on the remote control. A keypad message will appear requesting precision for the type of
remote control connected.
CONNECT-5 selection mode.
THE «FREE» PROGRAMME
The «free» programme matches the current context by default.
The MMI (man machine interface) gives access to different settings:
IHM with TFT
screen
The higher bar is accessible but with restrictions :
- Process : TIG – MMA
- Type : DC – AC – SYNC - AC MIX
- Ø : OK
- Sub-process : STD – PULSE – SPOT … : OK
- Type of trigger : 2T only
- Arcing : OK
- Option : deactivated
- Files : OK
- Welding and settings cycle : OK
Keypad
- Process & Arcing : TIG-HF – TIG-LIFT – MMA
- Type of trigger : deactivated for 2T only
- Sub-process : STD - PULSE - Easy Pulse - SPOT : OK
- SAVE / RECALL : deactivated
- Welding and settings cycle : OK
ARC ON
L’ARC ON is a piece of information sent by the welding machine and equal to the state of the welding arc.
During a welding cycle, the ARC ON is at 0 while the arc is on (from I_Start to I_Stop).
L’ARC ON is at 1 while the arc is off (during the Pregas or Postgas phases but also if the arc stops because the machine encountered a problem).
