11
GYSFLASH 10.36/48 PL
Lithium Iron Phosphate Charging Mode (54 V/8 A max) :
Mode for charging 48V LiFePO4 batteries with 15 cells in series from 8 Ah to 160 Ah.. 8 step automatic
maintenance charge cycle.
Lithium Iron Phosphate Charging Mode (57.6 V/8 A max) :
Mode for charging 48 V LiFePO4 batteries with 16 cells in series from 8 Ah to 160 Ah. 8 step automatic
maintenance charge cycle.
Standard Lithium-ion charging mode (54 V/8 A max) :
Mode for charging standard 48 V Li-ion batteries with 13 cells in series from 8 Ah to 160 Ah. 8 step auto-
matic maintenance charge cycle.
Standard Lithium-ion charging mode (58.1 V/8 A max) :
Mode for charging standard lithium-ion batteries with 14 cells in series from 8 Ah to 160 Ah. 8 step auto-
matic maintenance charge cycle
Some Lithium batteries incorporate a UVP protection (Under Voltage Protection) which
disconnect the battery in case of deep discharge. This protection prevents the charger from
detecting the battery. In order for the Gysflash 10.36/48 PL to charge the battery, the UVP
protection must be disabled. To do this, select the Lithium charging mode and press the
button
for 10 seconds. The charger will then deactivate the UVP protection and
automatically start charging.
In 48V lithium-ion charging mode (LFP or standard), press and hold button
for 3s to switch between 54V and 58V
charging voltages depending on the number of serial cells in your battery..
• Battery type selection :
Using button
, , select your battery type from the following three technology categories :
Lead-acid, AGM, GEL, etc.
LiFePO4
NMC, NCA, Li-Po, LCO, MCO, …
• Load curve Lead :
The GYSflash 10.36/48 PL uses an advanced 7-step lead charging curve that guarantees the optimal performance of your lead-acid
battery.
Step
1
: Analysis
Analyses the state of the battery (charge level, polarity inver-
sion, wrong battery…)
Step
5
: Charge
(
- 10 A /
- 8 A)
Fast charge at maximum current to reach 80% charge level.
Step
2
: Recovery
(
- 4 A /
- 3 A)
Recovering damaged elements after deep and prolonged
discharge.
Step
6
: Absorption
(
- 43.8 V /
- 58.4 V)
Constant voltage charge to reach 100% charge level.
EN
Translation of the original instructions
