1
2
4 5 6
7
8
3
2
9 17
3
3
7
8
9 17
NM53e - Page 2
Figure 1
II. Maintenance:
1 -
A regular cleaning of the apparatus allows better viewing of the problems, if any (distortion, breakage, or corrosion).
2 -
Before use, check wear parts each time for good condition and operation: cylinder
(12)
, stop tube
(11)
and standing board
(1)
,
as well as presence of endpieces
(19)
,
(20)
and
(21)
.
3 -
Check the correct tightening of all attachment elements.
4 - Important:
-
If a problem is detected or suspected, do not use the equipment as long as it has not been checked by a technician.
-
Any damaged or distorted piece should be replaced as soon as possible.
III. Storage:
Always store the equipment away from humidity and heat.
I. Assembly
(minimum of two people required)
:
Note:
Prepare a clean area for assembling the apparatus.
1 -
Installing the board
(1)
onto the rocking frame
(2)
:
-
Select the board
(1)
attaching direction (lengthwise as shown by
Fig. 1
or widthwise as shown by
Fig. 2
), depending
on the requirement.
-
Secure it using screws
(4)
+
(5)
+
(6)
.
Figure 2
2 -
Installing the platform onto the apparatus upright (upper upright on asymmetric
bars with stays, or onto the ring frame
Ref.: 3700):
- Important:
this equipment should never be installed on rounded uprights. You are
strongly advised against installing it onto the high bar for training (Ref.: 3210B -
3125B), as the platform restricts the useful adjustment range of the apparatus.
-
Position and hold the platform at the desired height against the apparatus upright.
-
Fix the assembly using the tightening plates
(7)
and screws
(8)
,
(17)
and
(9)
:
moderately tighten to prevent distorting the apparatus upright.
