Gymna PULSON 200, User Manual

Page: 32 / 56

Pulson 200
33
6 M
ALFUNCTIONS
,
SERVICE AND GUARANTEE
6.1 Malfunctions
6.1.1 Equipment cannot be switched on
1. Check if the mains voltage has failed.
2. Check if the main switch is switched on (“I”).
3. Check if the power cord and the fuses are in order. If necessary, replace
the fuse. See §6.1.2.
4. Contact your dealer if the equipment still cannot be switched on.
6.1.2 Replacing a fuse
1. Switch the main switch off (“O”).
2. Unplug the power cord from the equipment.
3. Pull the fuse holder carefully out of the equipment. If necessary, use a
screwdriver.
4. Replace the fuse. Only use the fuses supplied. If necessary, order new
fuses from your dealer.
5. Install the fuse holder and plug in the power cord.
6. Switch the main switch on again (“I”).
6.1.3 Equipment does not react to commands or an error
message appears
The safety system of the equipment has ascertained a fault. You cannot
continue to work. An instruction usually appears on the screen.
1. Disconnect the connection to the patient.
2. Switch the main switch off (“O”).
3. Wait 5 seconds and switch the main switch on again (“I”).
4. Contact your dealer if the error message reappears.
Component Problem Solution
Pulson 200 Equipment cannot be
switched on See §6.1.1.
Equipment does not react to
commands or a fault report
appears See §6.1.3.
Foreign language on the
screen Change the language. See
§4.5.2.