Precautions
•
Read all of these instructions and save them for later use.
•
Follow all warnings and instructions on the product.
•
Product
-
Do not cover or block the vent holes in the case.
-
Do not insert sharp objects or spill liquid into the LCD monitor through cabinet slots.
They may cause accident fire, electric shock or failure.
-
Disconnect the power plug from the AC outlet if you will not use it for an indefinite period
of time.
-
Do not attempt to service this product yourself, as opening or removing covers may
expose you to dangerous voltage points or other risks.
-
Do not touch the screen directly with your fingers. You may damage the screen, and oil
from your skin is difficult to move.
-
Do not apply pressure to the screen. The LCD is very delicate.
•
Power
-
Use the type of power indicated on the marking label.
•
Plugs
-
Do not remove any of the prongs of the monitor's three-pronged power plug.
-
Disconnect the power plug from the AC outlet under following conditions:
If you will not use it for an indefinite period time.
When the power cord or plug is damaged or frayed.
If the product does not operate normally when the operating instructions are
followed. Adjust only those controls that are covered by the operating
instructions. Improper adjustment of other controls may result in damage and
will often require extensive work by a qualified technician to restore the product
to normal operation.
If the product has been dropped or the cabinet has been damaged.
If the product exhibits a distinct change in performance, indicating a need for
service.
•
Power and extension cords
-
Do not allow anything to rest on the power cord.
-
Do not locate this product where persons will walk on the cord.
-
Use the proper power cord with correct attachment plug type. If the power source is 120 V
AC, use a power cord that has UL and C-UL approvals. If the power source is a 240 V AC
supply, use the tandem (T blade) type attachment plug with ground conductor power
cord that meets the respective European country's safety regulations, such as VDE for
Germany.
-
Do not overload wall outlets or power cords. Ensure that the total of all units plugged into
the wall outlet does not exceed 10 amperes.
-
Ensure that the total ampere ratings on all units plugged into the extension cord is not
above the cord's rating.
-
If the power supply cord, which came with your monitor, is to be connected to the PC
instead of the wall outlet, this equipment is to be used
with
UL/TÜV
approved
computers with receptacle rated 100~240V AC, 50/60Hz, 1.0A (minimum).
•
Environment
-
Place the monitor on a flat and leveled surface.
-
Place the monitor in a well-ventilated place.
1
