7
Prepare Your Camera for use
Charging your Lithium battery
To charge your battery, you only need to connect your camera to PC with supplied USB cable correctly.
The LED will light up and it will be off after full charge.
Install SD memory card
This camera supports any compatible SD memory card up to 32GB. Limited internal memory is only for
you to take test photo; these photos will be lost when you turn off your camera or remove away the
battery. So that insert an SD memory card is normally for use. Please refer to the
below diagram for correct installation.
1.
Locate the SD Card slot on bottom of the camera.
2.
Insert the Memory card into the slot in the correct direction. (see the sketch below)
3.
Push the card in until you feel it “click” into position. An icon “SD” will appear
on the top left of LCD screen after you turn on your camera.
4.
Once the external memory card is inserted into the camera all the images
taken with the camera will be stored on the card.
5.
Please make sure the card is not locked. No images can be transferred
to the card if it is locked.
7
Prepare Your Camera for use
Your digital camera needs a
Lithium battery in order to operate.
1. Slide and open the battery door in the right side of the camera.
2. Push aside the green button which is in the battery compartment.
3. Insert the battery correctly with the correct polarity facing up.
4. Close the battery door.
5. On powering on your camera the battery icon will appear at the bottom right of the LCD Screen.
Full battery power
Medium battery power
Low battery power
Note:
1.
A “
Low battery
”
message will flash on the LCD when the battery power is insufficient. Shortly thereafter
your camera will power off.
2.
Test photos taken with the camera should be downloaded otherwise they will be lost when the camera
loses power.
