Guzzanti ZRW, Instruction Manual, Page: 44 / 46

5
3.2 Setting the odour absorber mode of operation of the hood
In this option filtered air returns to the room through openings in the front of the hood.
In this setting it is necessary to install the carbon filter (Fig. 6).
6 Operation and maintenance
1. Operational safety
All safety instructions included in chapter IV must be observed. Textile grease filters and
carbon filters should be replaced and aluminium filter should be cleaned according to
manufacturer’s instructions, or more frequently in periods of intensive use (more than
4 hours a day). If a gas cooker is used it is forbidden to leave uncovered flame. When
removing pots from gas burners set the flame to its minimum level. Always make sure that
flame does not extend outside the pot. Such a situation causes undesired energy losses
and dangerous heat build-ups. The hood should not be used for other purposes than those
for which it was designed.
2. Operation:
2.1 Control panel
Fig. 4
Operation of the hood can be controlled by means of switches „W” and „O” (Fig. 4):
- switch „O” controls lighting. Shifting the switch to the left turns the lighting on, to the right
- turns the lighting off.
- switch „W” is used to control the hood motor. Successive shifts to the left turn on three
fan operation speeds. These control options enable the user to set the optimum fan
speed for his requirements at minimum noise.
3. Maintenance.
Regular maintenance and cleaning of the device will guarantee its good and fault-less
operation, and extend its life. Attention should be paid to replacing grease and carbon
filters according to instructions.