![background image](http://html1.mh-extra.com/html/guzzanti/gz-600b/gz-600b_manual_2279512025.webp)
MAINTENANCE
ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical
supply by switching off at the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be removed
from the socket.
CLEANING
The cooker hood should be cleaned regularly (at least with the same frequency with which you carry
out maintenance of the fat filters) internally and externally. Clean using the cloth dampened with neu-
tral liquid detergent. Do not use abrasive products.
DO NOT USE ALCOHOL!
WARNING:
Failure to carry out the basic cleaning recommendations of the cooker hood and replace-
ment of the filters may cause fire risks. Therefore, we recommend observing these instructions. The
manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inap-
propriate maintenance or failure to observe the above safety recommendations.
GREASE FILTER
Traps cooking grease particles. The grease filter must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short
cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its
filtering capacity. To remove the grease filter, pull the spring release handle.
CHARCOAL FILTER
(filter version only)
It absorbs unpleasant odours caused by cooking. The saturation of the charcoal filter occurs after more
or less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease
filter. In any case it is necessary to replace the cartridge at least every four mounths. The charcoal filter
may NOT be washed or regenerated.
REPLACING LAMPS
Disconnect the hood from the electricity.
Warning!
Prior to touching the light bulbs ensure they are cooled down.
•
Using a flat head screwdriver or equivalent tool, carefully pry loose the light cover.
•
Remove the damaged light and replace with a new 12 Volt, 20 Watt (Maximum) halogen light
made for a G-4 base SUITABLE FOR USE IN OPEN LUMINAIRES. Follow package directions and
do not touch new light with bare hands.
•
Reinstall the light cover. (it will snap shut).
If the lights do not work, make sure that the lamps are fitted properly into their housings before you
call for technical assistance.
EN - COOKER HOOD
25