GUTMANN mega macs 56, User Manual

Page: 72 / 102

Working with the Device mega macs 56 Bike
Diagnostics
12. Confirm the performed service reset with .
7.4.5.2 Performing Automatic Service Resets
Proceed as follows to perform the automatic service reset:
1. Perform steps 1 to 10 as described in the section Vehicle selection (Page 59) .
CAUTION
Rolling of vehicle
Risk of injury or material damage
Proceed as follows before starting:
1. Prevent the vehicle from rolling.
2. No gear is engaged.
3. Regard the window with infos and instructions.
NOTICE
Short circuit and voltage peaks when connecting the DT VCI
Danger of destruction of automotive electronics
Switch off ignition before connecting the DT VCI to the vehicle.
2. Insert the DT VCI into the vehicle's diagnostic connector.
Both LEDs of the DT VCI flash. The DT VCI is ready for operation.
3. Select Diagnostics > Function > Service reset .
NOTE
The selection of the following possibilities depends on the selected manufacturer and vehicle
type:
• Functions
• Assemblies
• Systems
• Data
4. Select the requested system.
5. Observe the info window.
6. Call up the >Information< tab.
7. Follow the instructions on the screen.
8. Start the automatic service reset with .
9. Select the OBD plug and subsystem where necessary.
10. Regard the window with infos and instructions.
11. Confirm the window with infos and instructions with .
Communication to vehicle is being established. The service reset will be done automatically.
The message Service interval reset appears if the service reset was successful.
12. Confirm the info window with .
72