mega macs 42 SE Bike
5. Confirm the warning notice with
ENTER
.
NOTE
The selection of the following possibilities depends on the selected manufacturer and vehicle
type:
•
Functions
•
Assemblies
•
Systems
•
Data
6. Select and confirm the requested assembly.
7. Select and confirm the requested system.
8. Select and confirm further sub-categories where necessary.
9. Regard the window with infos and instructions.
10. Confirm the window with infos and instructions with
ENTER
.
Communication to vehicle is being established.
NOTE
If the vehicle offers the automatic actuator test, all ECUs and actuators connected to them will
be automatically actuated one after the other.
The actuator test of a component must be finished completely first before the next test can be
started.
11. Activate the requested component with
and
ENTER
.
The actuator test is performed.
The message
Actuator test successfully done.
appears if the actuator test was successful.
7.3.6
Service reset
Use this menu to reset service intervals provided that this function is supported by the vehicle. The device performs
the resets either automatically or you find a description for the manual reset procedure.
7.3.6.1
Performing Manual Service Resets
Proceed as follows to perform the manual service reset:
1. Perform steps 1 to 5 as described in the section
.
CAUTION
Rolling of vehicle
Risk of injury or material damage
Proceed as follows before starting:
1. Prevent the vehicle from rolling.
2. No gear is engaged.
3. Regard the window with infos and instructions.
NOTICE
Short circuit and voltage peaks when connecting the DT VCI
Danger of destruction of automotive electronics
Switch off ignition before connecting the DT VCI to the vehicle.
40
