14
PROBLEM:
Temperature of top housing has dropped below 34.5° C after
initially reaching set point.
REMEDY:
Turn off the simulator. Move simulator into a warmer environ-
ment. Wait a few minutes then turn back on. If the condition continues to occur
the simulator requires service.*
PROBLEM:
Temperature of top housing has risen above 36.0° C.
REMEDY:
Turn off the simulator. Move simulator into a cooler environment.
Wait a few minutes then turn back on. If the condition continues to occur the
simulator requires service.*
PROBLEM:
Excessive amount of time for top housing temperature to in-
crease. The heating element may be open or the top housing was too cold.
REMEDY:
Reset the simulator. If the top housing does not heat, the heating
element may be defective. Requires service.*
