8 I 19
3.2.2 Tool setting via pushbutton and LED indication
The device is equipped with a push button and one LED that can indicate red and green.
This allows to enforce some fundamental settings.
•
Switch the device into the sleep mode and wake it up from the sleep mode:
In the sleep mode nearly all functions of the device are disabled and the power
consumption is reduced to the minimum. This mode is designated for longer periods
of non-usage. The only available function is to be prepared for a wake-up.
To enforce the device to go into the sleep mode press the push button for more than
two seconds. The LED will indicate the transition by flashing five times in red.
If the dvice is in the sleep mode and you intend to wake it up also push the button for
at least 2 seconds. The LED will indicate the transition by flashing five times in green.
See also chapter 5 Storage and transportation
•
Sending a test e-mail:
To enforce the sending of a test e-mail push the button two times less than one
second. The LED will continuously be red during this test. Thereafter it will flash five
times red when the test failed or five times green when the test was successful.
The LED will go off and on in between the test (without flashing), therefore wait for
at least 2 minutes before trying another test!
