Feed the device with the gas and pressure as specified on device information plate and adjusted. If
the gas type to which the device was adjusted for is not suitable to the gas type at the mounted place,
follow the instructions written below.
ATTENTION: All adjustments and modifications to be performed on the gas installation and
connection of the device should be performed by authorized people.
ADJUSTMENT ACCORDING TO DIFFERENT GAS TYPES
If the device is connected to gas installation, close main gas inlet valve.
Replacement of top burner nozzles ( Figure B)
a.
Remove cooker grater(1), top burner cover (2) and oil tray (3)
b.
Replace nozzle (5) with a nozzle suitable for the gas type
c.
Adjust the flame of the pilot burner by turning the bolt (4)
OPERATOR INSTRUCTIONS AND ATTENTION POINTS
Make sure to turn the device on and wait before attempting to cook. This will ensure the evaporation of the
protective oil on top.
When you do not cook, keep the adjustment button on
position. It will provide a more economical usage
for you.
Check the water level in the drawer periodically. Replace the water if the water level is down.
Clean the grill mouldings everyday with a suitable tool. This will help clean the carbonized and burned food
residues and will ensure the cooking efficiency.
Oil cabinet should be cleaned after usage each time.
If the buyer intends not to use the grill for a long period of time, the grill mouldings should be oiled and
stored in a place with no humidity.
The back-side chimneys should not be blocked at any time.
The water-oil mixture can be discharged from the discharge valve at the back of the device.
No food should be left at the cabinet part of the unit.
START-UP
Put water in the water cabinet (7) (Figure C) (G7V100G 5lt, G7V200G 10lt). Do not start-up with no water
inside.
Turn on the main gas valve.
Put the grill gas button (5) to “
” position.
At this position fire up the pilot (6). After firing up the pilot keep pressure on the botton at least 10 seconds
to make sure the thermocupul is heated up.
You can adjust the flames to the reuired level by toggling
or
signs
If the device is operated for the first time, keep the button pressed at pilot burner flame position for a while
before ignition to discharge the air in the gas installation.
Top surface temerature should be smaller than K80
TURNING OFF
Turn the button (6) to position
.Then it will be just the pilot flame is lit
To fully turn the device off, get the indicator to ‘0’ sign.