Single Phase
Refer to the wire drawing inside the electrical box and above for proper motor and transformer
connections, lead selection and wiring vonnections from the motor to the power source for the
voltage you are using. Important: Immediately after wiring the machine, remover the drive belt,
turn on the power and make sure the motor is running in the right direction (counter-clockwise
when looking at the motor shaft. )
Three Phase
Refer to the wire drawing inside the electrical box and above for proper motor and transformer
connections, lead selection and wiring connections from the motor to the power source for the
voltage yor are using. Important: Immediately after wiring the machine, remove the drive belt, turn
on the power and make sure the motor is running in the right direction(counter-clockwise when
looking at the motor shaft.) If it is not, disconnect the machine from the power sou re and inter
change any two lead lines.
General Opera ting Instructions
Remvoing and Installing the Blade
When your machine was shipped, a blade was supplied and assembled to the saw. When
selectint a new blade refer to the selection of sawblades. The machine requires requires a
blade1 " , 032" X1191/2''
(27MMX9MMX035MM)
1 . Disconnect the machine from the power source.
2. Raise the saw frame about 6" and close the feed control valve by turning it clockwise as
far as it will go. (Do Not Overtighten. )
3 . Open both wheel covers and clean
the chips out of the machine.
4 . Release blade tension by turning
the blade tension handwheel CC)
Fig. 1 counter-clockwise.
5 . Slide left blade guide arm to the
right as far as possible.
6 . Remove the blade from both wheeles
and out of each blade guide.
7 . Make sure the teeth of the new
blade are pointing in the direction
of travel. If necessary.turn the blade
inside out.
C
Fig. 1
7
