Guntermann & Drunck DVI-Vision-CAT series, Installation And Operating Manual

Page: 90 / 148

Installation
13 · G&D DVI-Vision-CAT
Connecting audio and RS232 interfaces
Micro In: If required, connect a microphone to this interface.
Speaker: Connect the speakers or another audio output device.
RS232: Connect the serial end device to this interface.
Connecting further interfaces of ARU/ARU2 variants
USB 2.0 Devices: Use the two interface on the back and the two interfaces on the front
to connect USB devices.
USB 2.0 Trans.
Plug a category 5e (or better) twisted pair cable, which is available as
accessory, into this interface of the
ARU2
variant. Connect the other end of the cable
to the
USB 2.0 Trans.
interface of the computer module.
NOTE: The USB 2.0 Devices interfaces of ARU and ARU2 variants support different
data rates:
 ARU variants: full speed
 ARU2 variants: high speed
USB 2.0 Devices
USB 2.0 Trans.
Micro In Speaker
Main P
ower
DVI/VGA Out Red. Power
Mouse
Keyb.
Generic
Keyb./Mouse Transmission
RS232
Micro In Speaker
RS232
Main P
ower
DVI/VGA Out Red. Power
Mouse
Keyb.
Generic
Keyb./Mouse Transmission
USB 2.0 Trans.
USB 2.0 Devices