CLEANING & MAINTENANCE& USE
14
Cleaning The Magnet Jet (Step by Step)
Magnet Jet Components
1. Pull Magnet Jet Cap off from the Retainer Plate in the pedicure bowl.
2. Remove blackheaded banana plug from outside rim.
3. Turn the Top Cover off the Magnetic Jet Cap counter-clockwise.
4. Separate the three components of the Magnetic Jet Cap: Top Cover, Magnet and Back Cover.
5. Wash each component of the Magnetic Jet Cap in a recommended or high quality solution or cleaning agent.
6. Reassemble the Magnet Jet Cap using the following directions:
- Put the Magnet, with the three circles facing upwards, in the center of the Back Cover.
- Take Top Cover and place over Magnet, offset pre-drilled holes on the outer edge, twist Top Cover,
clockwise with Back Cover until holes are aligned, push in banana plug.
- Remount the Magnetic Jet Cap over the white pegs on Retainer Plate in pedicure bowl
so that the banana plug is at the top.
Back Plate
with Insert
Back Plate
Insert
Magnet front
Rubber Ring
Top Plate
(Wet end)
Magnet back
with ball
Banana Plug
Warning
!
- Do not run
Cleanjet
®
MAX without water. This will
void
your warranty
- Do not place two wet ends in the same bowl when cleaning
the jet’s strong magnets could cause
injury
(pins your fingers)
- Do not attach two wet ends to each other. Doing so will cause
breakage to wet ends and will
void
the warranty
