Control Panel
OPERATIONS & USE
11
1.
To fill water:
The foot-spa is provided with a single hot and cold mixing valve located on the front of your spa.
This is a pressure balance valve that requires you to lift the handle to start the water flow and to adjust to the
temperature that is desired. The clean jet body must be completely submerged in water.
CAUTION: DO NOT USE FOAMING, SUDSING OR MINERAL OIL BASED ADDITIVES IN THE WATER.
2.
To start whirlpool:
Press the button as shown. This will start your Clean Jet motor. You may stop the whirlpool function at any time by
pressing the button again.
3.
To drain Footspa bowl:
Turn drain control knob to "pop-up" drain plug.
- If gravity drain (no discharge pump); water in bowl empties with duration determined by waste water plumbing
characteristics.
- If optional discharge pump has been installed; then press discharge pump button to activate 2-minute timer
controlled pump. Average drain time approximately one minute (depending on plumbing characteristics).
4. The Shiatsu Roller back massage Chairs are equipped with a state of-the-art robotic massage system.
This system is easy to use. The remote has a one-touch power button that initiates a pre-programmed massage
session. Various massage functions are also available for selection via this remote. The chair's position can also be
adjusted; forward/backward as well as reclined to the client's preference (see illustrations on page 12).
Note: Read and Follow Chair Manual Instructions
BASIC PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE FOLLOWING:
1. Read and follow all instructions
2.
DANGER
. To reduce the risk of injury, do not permit children to use this unit unless they are supervised
at all times.
3. Use this unit only for its intended use as described in this manual. Do not use attachments that are not
recommended by the manufacturer.
4. Never drop or insert any object into any opening.
5. Do not block jets during whirlpool operation.
6. The unit must be connected to an electrical supply circuit that is protected by a ground fault circuit interrupter.
7. The clean jet motor is magnetically driven and is insulated twice. Therefore it does not require to be bonded.
Save these instructions
Water Mixer Control
Drain Control
Jet Control
Hand Spray
