Gulf Coast Spas DX 5000, Owner'S Manual

Page: 31 / 52

29
PROBLEM CAUSE SOLUTION
Pump not
running No power to
spa Reset circuit breakers on GFCI panel
and main circuit breaker panel
Water does Air lock Bleed air from the system (page 27)
not flow Closed Jets Open all jets by turning
counterclockwise
ACV open Close air control valves
Water too
hot High set
temperature Turn down set temperature on
topside control panel
High
ambient
temperature Remove the cover from the spa
Water will
not heat Thermostat is
set too low Check and reset to desired
temperature
Air open Close air control valve
Dirty filter Check and clean filter
Blown fuse Check and replace fuse
Slide valve
closed Check and open all valves
Cover off Put cover back on spa
Spa in
Economy
mode Press the Standby button and take
spa out of Economy (see
Economy
Mode on page 21)
Error Codes
MESSAGE MEANING ACTION REQUIRED
(none ) No message on
display. Power has
been cut off to spa. The control panel will be
disabled until power returns.
Spa settings are preserved
HH The spa has shut down
from high heat
detection. One of the
sensors detected 118ºF
(48ºC) at the heater. Do not enter the water.
Remove the spa cover and
allow the water to cool. Once
the heater has cooled, reset
by pushing any button. If the
spa does not reset, shut off
the power to the spa and call
service.