Gulf Coast Spas DX 5000, Owner'S Manual

Page: 10 / 52

8
E l e c t r i c a l S p e c i f i c a t i o n s
Important – Qualified and licensed electricians must perform all
electrical hookups. The following specifications must be followed in
order to ensure proper performance and safety.
WARNING: Starting an incorrectly wired spa could cause
severe damage to the mechanical equipment or
even bodily harm. Have your licensed electrician
verify GFCI (or RCD) wiring with the schematics on
pages 9-13 prior to starting the spa or call the
technical support line at (866) 697-4528.
Caution: Failure to abide by specifications listed may result in
damage to the equipment and will void the warranty.
US/Canada:
All spas must be wired with a properly-sized GFCI breaker (see
table below). Failure to do so will cause equipment damage and
will not be covered under your warranty.
All spas must be protected with an over current protective device
with built-in GFCI in the service panel.
Model Volts Freq.
Rating
Amps
GFCI
Amps Wire size Controller
DX 5000 240/120 60 32 40 6-3 plus ground VS500Z
DX 5000
(Europe)
220-240 50
1x32
or 2x16
IEE wire
regulation
3 or 5 Wires 4mm² GS500Z
LX 4000 240 60 40 50 6-3 plus ground VS501Z
LX 4000
(Europe)
220-240 50
1x32
or 2x16
IEE wire
regulation
3 or 5 Wires 4mm² GS501Z
EX 3000 120/240 60 16 20 12-3 cord with GFCI plug VS500Z
EX 3000 240/120 60 32 40 6-3 plus ground VS500Z
IX 40
240 60 40 50 6-3 plus ground VS501Z
EUROPE:
WARNING: Disconnect the electrical power before servicing.
Before obtaining access to terminals, all supply
circuits must be disconnected.
Avertissement: Disconnecter du circuit d'alimentation
electrique avent l'entretien.