32
33
Therefore, the following safety rules MUST be followed:
1. The safety chain/strap must always be used when working under the plat-
form.
2. The lifting platform must NOT be raised or lowered while working under the
platform, even when the safety equipment is assembled.
3. Once the platform is assembled and connected so that it can be raised and
lowered, only one person may work on it at a time.
Safety equipment
When working under the platform, the
safety chain/strap MUST be used.
The safety chain/strap is fitted between
the special safety eyelets on the scissors
or the two central tubes of the scissors
(see picture). Once the chain/strap has
been fitted, lower the platform until the
chain is taut, i.e. until the traction wheel
“releases“ the curve.
1.06
Assembly
The LP4 and the safety gate must be assembled by the Guldmann Service
Team or authorized representative.
Caution!
The platform must not be activated before railing, ramp and end cover are
installed.
Mounting of the railing
1. In both sides of the safety edge there is a lock mechanism for the railing.
2. The railing should be placed on both lock mechanisms and be fastened inside
the safety edge with a 13 mm open end wrench.
3. Check that the railing is firm.
Mounting of the ramp
1. Position the ramp at the opening of the
safety edge. Unscrew the top nut (1),
and install and fasten the chain.
2. Fasten the ramp to the hinges (2) on
either side, and check that it can be
moved up and down easily
3. Install the end covers at the end of the
safety edges and test the functions of
the lifting platform.
