6
©
Guldmann G
B
/U
S
-1
0/
20
19
•
#
558350_1
©
Guldmann G
B
/U
S
-1
0/
20
19
•
#
558350_1
4 .00
Unpacking and preparation of the lifter
Visual check of lifter
If the packaging is damaged on receipt, each part of the lifter must be careful-
ly examined for visible defects or deficiencies. In case of suspected damage,
do not use the lifter until authorized by qualified service staff or the Guldmann
Service Team.
4 .01
Assembly instruction
Guldmann recommends that the person making the assembly of the mobile
lifter have a basis mechanical understanding.
Unpack the lifter on a level surface and gently remove cable ties and protec-
tive-foam.
Assembling mast/chassis – electrical
Loosen screw
(pos. 3)
fitted to mast. Posi
-
tion the mast
(pos. 1)
in the Chassis
(pos. 2)
.
Make sure that the mast hits the chassis in
the bottom of the chassis tube, tighten screw
using an M5 Allen key. To dismantle, remove
screw to pull mast out of base. Retighten
screw in mast.
Fitting actuator
Fasten the actuator base
(pos. 4)
using the
attached screw
(pos. 6)
with nut
(pos. 7)
.
Fasten the actuator top
(pos. 4)
using the
attached washers
(pos. 5)
and screw
(pos. 6)
with nut
(pos. 7)
.
Tighten screw and nut with 17 mm spanners.
Note:
Actuators with motor housing turned 90°
must have the motor pointing to the left side
when you are facing the actuator directly.
Complete by adding protective caps
(pos. 8)
on nut and bolt.
1
2
3
7
4
6
6
5
7
8
