12
Infrared remote control
1. Lift
2. Lower
3. Move hoist towards the open arrow
on the information panel of the hoist
4. Move hoist towards the closed arrow
on the information panel of the hoist
Note
There must be a load on the strap corresponding to the weight of Guldmann’s
lifting hanger before the lifting/lowering function will operate.
Transport/running in the rail system
Push the GH2 hoist manually into the rail system.
GH2+2/GH2+2R operates fully automatically on the rail system by pressing
the hand control/IR sender.
The GH2 hoist must not be exposed to sudden changes in temperature.
For instance, you must not take a cold hoist into a hot bathroom or similar.
2.04
Safety functions
The emergency stop and emergency lowering
device should be used only in an emergency
If, contrary to expectations, it becomes necessary to
use the safety functions, the fault must be located and
remedied before using the GH2 hoist again.
Please contact your supplier.
Re: EMC
If electromagnetic or other influences occur between
this product and other products, these products must
not be used together.
The function of the emergency strap
Pulling the red strap will activate the following functions:
• 1st pull: Emergency stop
• 2nd pull: Emergency
lowering (requires a constant, light pull).
Emergency stop
If the GH2 hoist does not respond to the hand control when in use, pull the
red strap lightly to deactivate all functions except the emergency lowering
function. When the emergency stop has been activated, the GH2 hoist will
no longer function.
The emergency stop’s contact arm must be pushed in manually before the
GH2 hoist will be ready for use again.
1
2
3
4
©
Guldmann
G
B
/U
S
-12
63/0
1
/0
8
•
#
90069
©
Guldmann
G
B
/U
S
-12
63/0
1
/0
8
•
#
90069
