REV.0 CODE G503155E PAGE 7
4.8 GENERATION OF A CALL TO THE PORTER’S UNIT WHEN THE EXTERNAL
PUSHBUTTON/CONTACT IS OPERATED
As in section 4.7, this operating mode is to advise from a pushbutton or contact external to the entry system, but in this
case the porter’s unit is advised instead of a dwelling. Likewise, any type of electrical/electronic device may be used,
such as motion detectors, smoke and fire detectors, etc. It can also be used to advise on the arrival of a visitor via an
access without a street panel or for any other type of warning, alarms, etc.
The adaptor must be configured as follows:
SWITCH A:
is configured with
a number other than those assigned to the
dwellings in the installation
(in the diagram, number 5).
SWITCH B: switch 3
must be in the ON position. The rest must remain OFF.
SWITCH C: switches 1 and 4
must be set to the ON position and the rest must be
OFF
.
The connections diagram for this operating mode is shown in
FIGURE 2
(page 7).
FIGURE 2: Connections schematic for the operating modes explained in sections 4.5, 4.6, 4.7 and
4.8.
R3660
BUS
2M
3M
1M
2M 3M
1M
1M 2M 3M
3M
1M
2M
3M
1M
2M
DIGITAL BUS
DIGITAL BUS
MONITOR OR
TELEPHONE
STREET PANEL
EXTERNAL
PUSHBUTTON/CONTACT
(Configure switches according to operation mode)
3
SWITCH A
1
2
7
8
6
4
5
1
2
SWITCH B
3
5
6
8
7
1
2
SWITCH C
3
4
5
6
8
7
4
