Customer Helpline 0333 3201989
13
18
19
Before reinserting a new or reverse blade, always clean both the blade and the blade seat
if dirty. Slide the blade into the clamp with a spanner (or a screwdriver) in the correct
orientation. Check the blade is equal with the clamp. Retighten the three blade screws with
the spanner.
Repeat the above procedure to change the other blade.
After the blades are replaced, check if the blades are parallel and in the same surface as
the rear base plate with a ruler. If not, you can adjust the blades with the hexagonal wrench
provided. Firstly loosen the three screws on the blade clamp. Turn the socket head screw
clockwise, the blade will be risen. Turn it anticlockwise, the blade will be lowered down.
Finally retighten the three screws fully.
10. REPLACING A DRIVE BELT (SEE FIG N, O)
WARNING:
1. Remove the plug from the socket before carrying out any adjustment, servicing or
maintenance.
2. The cutting blades will be turning and may cause injury.
3. Always put on gloves when operation.
Loosen the screws and remove the belt cover. Remove the worn drive belt from the large
pulley and the pinion and clean them. Lace the new belt on the top of the pinion and turn it
manually, press it on the large pulley. Make sure that the drive belt runs exactly along the
length grooves of the pinion and the pulley. Replace the belt cover. Install the cover screw
and tighten fully.
Operating Instructions
N
O
