Customer Helpline 0333 3201989
10
11
Operating Instructions
5. USING THE PARALLEL GUIDE (SEE FIG F)
Insert the screw provided through the hole on the support of parallel guide (7). Turn the
screw into the nut on the housing. Fix the parallel guide on the support of parallel guide
with the screw and nut. Ensure the screws are tightened securely.
NOTE: The parallel guide should be fitted on the left of housing.
To adjust the required width of cut, loosen the nut and slide the parallel guide to the
required position. Retighten the nut fully.
Use the parallel guide while cutting. The guide should be held firmly against the edge of the
workpiece.
6. USING THE REBATE (SEE FIG G)
Insert the screw (11) provided through the slot on the Rebate. Turn the screw into the nut on the
housing.
The cut depth adjustment can be set from 0 to 10mm.
To adjust the depth of cut, place the planer on a flat board, then loosen the screw and slide the
cut depth adjustment guide up and down for required depth. Tighten the thumb screw fully.
7. REBATING (SEE FIG H)
The width of rebating cut (a) is adjustable by moving the parallel guide. The depth of
rebating cut (b) is determined by moving the Rebate, and the number of passes made along
the workpiece. Make sure that the plane is guided with a lateral supporting pressure.
H
F
G
b
a
