Customer Helpline
0333 3201989
9
12
11
10
9
E
F
G
Operating Instructions
5. CHANGING A SANDING BELT
WARNING!
Remove the main plug from the socket before changing sanding
belt.
Pull the lever (9) to release the belt tension. Remove and fit a new belt over
both rollers (SEE FIG E). Ensure the direction of rotation arrows on the belt and the
sander are the same. Close the lever to tension the belt .
6. BELT CENTERING CONTROL
WARNING! Wear eye protection before carrying out a belt centering adjustment
Turn the tool upside down, hold it firmly with one hand, start the motor and release
the switch immediately after observing tracking of sanding belt. If abrasive belt runs
outward, turn tracking adjustment knob counter-clockwise and clockwise if belt runs
inward (SEE FIG F). Adjust the belt until the outer edge of the belt is even with the outer
edge of the base-plate (11). Belt life will be greatly increased by keeping the tracking
adjustment set properly .
7. DUST BAG (SEE FIG G)
You must use the dust collection bag provided to collect the dust produced during
sanding. The dust collection bag plastic bracket slides down onto the dust outlet on the
belt sander. When the dust collection bag is full, remove and empty by opening the zip
on the dust bag (12).
