Customer Helpline
0333 3201989
10
4. TRIGGER FLOW CONTROL (SEE FIG. E1-E4)
1) The flow rate of the glue is dependent on how much pressure is applied to the trigger
flow control. We add a case when you use the gun to bound interlayer. If you press the
interlayer, pls take care of overflowing glue.( see FIG. E2 - E3 )
Tip:
Ensure the glue sticks are heated fully to allow an even flow of glue.
2) Press the surfaces to be glued together within 15 seconds for a strong bond.
3) To stop the flow of glue from the gun, release the trigger flow control.
WARNING!
The glue gun nozzle and heated glue gun become hot while in use. In the
event of accidental skin contact with hot glue, run under cold water immediately.
Operating Instructions
E1
E3
E2
E4