Customer Helpline 0333 3201989
9
1
.
REMOVE THE WATER RESERVOIR LID (SEE FIG A1,A2,A3)
1) Lift the water reservoir lid (4) up firstly and lift the right side of the water reservoir lid (4),
then move to left for removing it.
2� INSTALL THE DIAMOND BLADE (SEE FIG B1- B8)
Loosen the screw (b) which is holding the splash guard to remove the splash guard (a).
Move the splash guard (a) to the left side and take it out.
Remove the locking nut(c) and the outer flange (d).
Fit the diamond blade (e) onto the inner flange (Note: please following the rotation direction
on the diamond blade). The direction arrows on the diamond blade must be in the same
direction as that marked on the wheel guard, or as that indicated around the spindle�
Ensure that the diamond blade (e) is fully located and centered by used small spanner for
locking nut (10) and big spanner for outer flange (11) to tighten it. Fit the big spanner for
outer flange (11) to outer flange (d) firstly and fit the small spanner for locking nut (10) to
the locking nut next. Then keep the small spanner for locking nut in the same place without
moving. lift the big spanner for outer flange (11) up to tighten.
NOTE: The outer flange (d) ensuring that the flat side of the flange is against the diamond
blade;
Push the splash guard back and tight the screw.
Operating Instructions
A1
A2
A3
Before you start