Customer Helpline 0333 3201989
14
FILLING THE WATER RESERVOIR (SEE FIG H)
●
Before cutting, the water reservoir must be filled with water.
Fill two-thirds of the tray of cold and clear water. The water can cool and lubricate the disk
during the cut and it also helps to remove dust.
WARNING! Do not add chemicals or detergents to the water.
MITRE CUTS (SEE FIG I1,I2,I3)
●
Lift up the water reservoir lid (4)
Pull out the two lid supports (o) located on the back of the water reservoir lid.
To cut 22.5° angles, place the two upper 22.5° miter stays(p) on the lid supports into the
two slots located inside the water reservoir.
To cut 45° angles, place the two lower 45° miter stays (q) on the lid supports into the two
slots located inside the water reservoir. Place the piece of tile facing down onto the water
reservoir lid then push the work piece towards the diamond blade.
Operating Instructions
Operation
o
p
q
H
I1
I2
I3