4
CAUTION!
DO NOT CONNECT THE POWER SUPPLY WIRES
TO ANY OF THE CONTROL WIRES.
DO NOT REVERSE THE RED (POSITIVE)
AND BLACK (NEGATIVE) POWER WIRES.
This light requires a source of 12 volt DC power that is capable of supplying 10 amps of
current. For best results, run two new wires from the red (
+
+
+
+
)
positive and black (
−
−
−
−
)
negative power wires of the light directly to the main 12 volt DC accessory panel. Install
fuses as shown in the diagrams on pages 4 and 5. A 10 amp circuit breaker can be
installed instead of an in-line 10 amp fuse.
If the light will be less than 30 feet (9M) from its power source, use 12 gauge (3mm)
wires. If the distance will be more than 30 feet (9M), use 10 gauge (5mm) wires.
Black
12 volts DC
Foam Gasket
10-12 ga. (5mm)
crimp Connector
10 Amp Fuse
(or circuit breaker)
Black
12 volts DC
Red
12 volts DC
1.
Connect the wires from the spotlight cable
to SAME wire colors of provided cable
Male Plugs on
this end of cable
2.
Connect the control cable wires to
SAME wire colors of provided cable
Do not use
blue wires
Red
12 volts DC
10 Amp Fuse
(included)
502-1 Spotlight Wiring Diagram
